HP DC7600 - HP

Desktop Management Guide www.hp.com 27
Desktop Management Guide
Network Service Boot Enables/disables the computer’s ability to boot from an
operating system installed on a network server. (Feature
available on NIC models only; the network controller must
reside on the PCI bus or be embedded on the system board.)
System IDs Allows you to set:
• Asset tag (18-byte identifier) and ownership Tag (80-byte
identifier displayed during POST).
See the Computer Setup (F10) Utility Guide on the
Documentation and Diagnostics CD for more information.
• Chassis serial number or Universal Unique Identifier
(UUID) number. The UUID can only be updated if the
current chassis serial number is invalid. (These ID
numbers are normally set in the factory and are used to
uniquely identify the system.)
Keyboard locale setting (for example, English or German) for
System ID entry.
DriveLock (some models) Allows you to assign or modify a master or user password for
ATA hard drives. When this feature is enabled, the user is
prompted to provide one of the DriveLock passwords during
POST. If neither is successfully entered, the hard drive will
remain inaccessible until one of the passwords is successfully
provided during a subsequent cold-boot sequence.
✎
This selection will only appear when at least one ATA
drive that supports the ATA Security command set is
attached to the system.
See the Computer Setup (F10) Utility Guide on the
Documentation and Diagnostics CD for more information.
Security Features Overview (Continued)
Option Description
✎
For more information about Computer Setup, see the Computer Setup (F10) Utility Guide on the
Documentation and Diagnostics CD.
Support for security features may vary depending on the specific computer configuration.