The problem is one image overlays another on the same
sheet
The I/O timeout setting may be too long. From the front panel, decrease the setting
and print again. Select the
icon, then I/O setup > I/O timeout.
The problem is pen settings seem to have no effect
Here are some possible explanations:
●
You have changed the settings in the front panel by selecting the
icon
followed by Printing defaults menu > HP-GL/2 settings > Define palette, but
you have forgotten to select that palette in Printing defaults menu > HP-GL/2
settings > Palette.
● If you want the software-driven pen settings, you must remember to go to the
front panel and select the
icon followed by Printing defaults menu > HP-
GL/2 settings > Palette, and set it to Software.
Chapter 14
206
The problem is an image error
To Next Page
Loading...
