17
The problem is something else
● The problem is the printer's start–up process does not complete
● The problem is a front panel message
● The problem is a “printhead monitoring” message
● The problem is a “printheads are limiting performance” message
● The problem is the printer does not print
● The problem is a print job is waiting for a time-out
● The problem is the printer seems slow
● The problem is communication failures between computer and printer
● The problem is I cannot access the Embedded Web Server from my browser
● The problem is an out-of-memory error
● The problem is an AutoCAD 2000 memory allocation error
● The problem is the platen rollers squeak
The problem is the printer's start–up process does not
complete
If the printer's start-up process stops when the front panel is displaying the number
17, this indicates that there is a problem with the file system on the printer's hard disk,
so the printer is checking the whole file system and making any necessary
corrections. This problem can arise when there has been a power cut while the printer
was switched on, or if there is a physical problem with the hard disk.
Checking the whole file system normally takes about half an hour. There is nothing
you can do to speed it up. If you turn off the printer, the file system check will restart
whenever you turn it on again.
If you experience this problem repeatedly when there has been no power cut, contact
your customer service representative.
The problem is a front panel message
The front panel displays messages of many kinds; some allow you to continue using
the printer while others require you to take action before you can continue.
● If the printer detects a condition of which you should be aware, it displays a
message for your information. Examples of information messages are
performance limiting conditions, and printer maintenance requirements. Once you
215
The problem is something else
To Next Page
Loading...
