16. The printer will adjust the paper by winding it back and forth, after which you can
expect the front panel message below.
17. Using the stops, carefully wind the excess paper back onto the spindle.
18. The printer will automatically perform printhead alignment and a color calibration
for the paper type that you have loaded. During this process the printer will
advance the paper by up to 3 m (≈10 ft) before printing. Please do not try to stop
the paper advance; it is necessary to ensure a successful printhead alignment.
The whole alignment and calibration process will take about twenty minutes;
while it is going on, you can start connecting the printer. See How do I connect
the printer?.
55
How do I assemble the printer?
To Next Page
Loading...
