HP Designjet 430 - Unloading media

2–25
Company confidential. Genie User’s Guide, Edition 2, First Draft. Freeze Status: open
This is the blue on page 2–25 (seq: 67)
This is the black on page 2–25 (seq: 67)
Unloading media
Drying time
On some media types, the ink needs to dry before the print is unloaded. Since the
printer knows which media type you are using, it allows the appropriate drying
time to elapse before the printing process is complete. During the drying time, the
appropriate media type light as well as the ready will flash. After the drying time
is complete, the flashing will stop, and the
Load Media light comes on to let you
know you can unload a printed roll. At any time you can terminate the drying time
by pressing the
Form Feed key.
Typical Drying Times (minutes)
Print Quality
HP Media Type
Fast Normal
or Best
HP Opaque Bond 0 1.5
HP Translucent Bond 0 1.0
HP Natural Tracing Paper 0 1.0
HP Vellum 0 3.0
HP Coated Paper 0 0.25
HP Heavyweight Coated Paper 0 0.25
HP Matte Film Not recom-
dd
4.5
HP Clear Film
men
d
e
d
4.5
HP High-Gloss White Film
HP High-Gloss Photo Paper
Not recom-
mended
3.0
3.0
Notice that you can unload some media types immediately.
MEDIA
2
Working with media
Unloading media
Localization Note.
450C/
455CA