2-6
System Error Codes
HP Designjet 4500 Printer Series Service Manual
System Error:
06:10
Problem
Description:
Main NVM failure - not detected, read/write failed or readback error.
Corrective Action:
Try the following:
Switch the Power OFF from the back of the Printer and disconnect the
Power cord. Reconnect the power cord and power On the Printer.
If the System Error continues, replace the Hard Disk Drive ⇒ Page 8-83.
System Error:
07:10
Problem
Description:
Aerosol Fan driver burnt.
Corrective Action:
Try the following:
Replace the Printer Interconnect PCA ⇒ Page 8-71.
If the System Error continues, replace the Gamut PCI PCA ⇒ Page 8-76.
System Error:
08:11
Problem
Description:
Problem with the Front Panel.
Corrective Action:
Try the following:
Switch the Power OFF from the back of the Printer and disconnect the
Power cord. Reconnect the power cord and power On the Printer.
Check that the Front Panel cable is not damaged and is correctly
connected to the Front Panel and to the Interconnect PCA.
Check that the Memory Module is installed correctly.
Check that the cables between the Interconnect PCA and the Main PCA
are not damaged and are correctly connected.
Check that the cables between the Hard Disk Drive and the Power Supply
Unit and the Main PCA are not damaged and are correctly connected.
Check that the cable between the Power Supply Unit and the Main PCA
is not damaged and is correctly connected.
Check that the Printer has the latest Firmware version. If not, update the
Firmware to the latest version.
Replace
the Main PCA ⇒ Page 8-81.
Replace
the Hard Disk Drive ⇒ Page 8-83.
R
eplace
the Memory Module ⇒ Page 8-79.
Replace the Printer Interconnect PCA ⇒ Page 8-71.
If the System Error continues,
replace the Front Panel ⇒ Page 8-27.
To Next Page
Loading...
