HP Designjet 4500

8-197
Removal and Installation
HP Designjet 4500 Printer Series Service Manual
Roll 2 BT Arm Assembly
Removal
Switch off the product and remove the power cable.
1. Remove the Roll 2 BT Arm Encoder Disc
⇒
Page 8-223.
The BT Arm Encoder Disc must be
removed to avoid damaging it
while removing the BT Arm
Assembly.
2. Remove Roll 2 Drawer
⇒ Page 8-186
3. Remove the Roll 2 Module ⇒ Page 8-190
4. Remove the Spring from the left side of the
BT Arm.
5. Remove one T-15 screw (Type G) that
secures the left side of the BT Arm.