128 Chapter 4 Service Tests, Utilities & Calibrations
Tests, Utilities & Calibrations
If there is a failure at this point, the Front Panel will display system error code 02.1:10 ⇒ see
page 79. Check also system error code 11 : 10
⇒ see page 81 or system error code 01.0:10 (refer
to page 78).
• Checking Carriage rev.
If there is a failure at this point, the Front Panel will display system error code 02.1:10
⇒ see
page 79. Check also system error code 11 : 10
⇒ see page 81.
21. A message will display on the Front Panel asking whether you would like to check the ISS
Communication. Select Yes and press OK to confirm your selection.
22. If you select Yes, the Printer will check the ISS Communication and the following information will be
displayed on the Front Panel:
• Starting Sausalito.
If there is a failure at this point, the Front Panel will display system error code 01.0:10 ⇒ page 78.
• Checking ISS PCA rev.
At this stage, the Front Panel displays the value for the ISS PCA revision and asking whether you
would like to Continue. Press any key to continue:.
23. When the Front Panel displays the following message, check that all the Ink cartridges are correctly
installed. Press any key to continue.
2.3 Power electronics
Description
This setting must be configured after installing a new Heaters Control Assembly. After installation, the
onsite engineer will have a coded number which came with the new part, this coded number must be
entered here in the menu. The coded number will enable the printer to accurately measure the voltage in
the Dryer Assembly. This is required in order to achieve a greater control of the power applied to the
system.
To Next Page
Loading...