376 Chapter 8 Removal & Installation
Removal & Installation
Waste Ink Tube
Removal
1. Remove the Right Cover
⇒
See page 319
.
2. Remove the Right Connector Cover
⇒
See page 341.
3. Remove the Primer Assembly
⇒
See page 355.
4. Remove the Primer Valves
⇒
See page 357.
5. Remove the Printhead Maintenance Cartridge
⇒
See
the User’s Guide.
6. Remove the Service Station
⇒
See page 364.
7. Remove the Drop Detector
⇒
See page 377.
8. Remove two T-8 screws that secures the top of the Drain
Tube to the Service Station (long screw driver or wrench
key required).
9. Slide off the Drain Tube from the Service Station.
WARNING!: Switch off the printer and remove the power cable.
To Next Page
Loading...