382 Chapter 8 Removal & Installation
Removal & Installation
13 . Remove five T-15 screws (Type G) that secure the Ink
Supply Tubes to the Carriage Assembly.
14 . Remove the Ink Supply Tubes from the Carriage
Assembly and safely place to one side of the Printer.
15. Remove one T-20 screw (Type B) from each plastic
holder at the rear of the Printer.
16. Remove one T-15 screw that attaches the bonding cable
to the printer chassis.
17. Disconnect the Air Tubes from the Ink Cartridge Tube
Connector.
To Next Page
Loading...