Encoder Strip and Encoder Sensor 401
Removal & Installation
11. Remove one T-8 (Type L) screw that secures the
Encoder Sensor to the Carriage Assembly.
12. Remove the plastic cover from the Encoder Sensor.
13 . Remove the Encoder Sensor from the Printer.
NOTE: After installing the NEW Encoder
Strip and Encoder Sensor, perform the
following Service Calibration:
• “5.5.1 Scan Axis Calibration”
⇒
page 213
.
• Reset the life counter “4.5.4 Encoder Strip
cycles”
⇒
page 200.
To Next Page
Loading...