Carriage Flex Cables 405
Removal & Installation
Carriage Flex Cables
Removal
1. Remove the Right Cover
⇒
See page 319
.
2. Remove the Front Panel
⇒
See page 353
.
3. Remove the Primer Assembly
⇒
See page 355
.
4. Press the two side of the Carriage PCA Cover and
unclip from the Carriage Assembly.
5. Use a flat bladed screwdriver to release the ALL the
clips, securing the Carriage Flex Cables to the
Carriage Assembly, by pulling upwards.
6. Disconnect the ALL the Flex Cables from the Carriage
PCA.
WARNING!: Switch off the printer and remove the power cable.
To Next Page
Loading...