HP Designjet L25500 Printer series - Page 471

Heaters Control Assembly 465
Removal & Installation
Heaters Control Assembly
Removal
1. Remove:
• For the 42-inch model, the Left Connector Cover
⇒ See page 343.
• For the 60-inch model, the Electronics Module
Extension⇒ See page 344.
2. Remove four T-20 screws (Type A) that secure the PSU
cover.
3. Remove the PSU Cover from the Printer.
4. Remove two T-20 screws from the AC Dryer Input
Assembly.
WARNING!: Switch off the printer and remove the power cable.
1
2