Heaters Control Assembly Fan 473
Removal & Installation
Heaters Control Assembly Fan
Removal
1. Remove the Left Connector Cover:
• For the 42-inch model ⇒ See page 343.
• For the 60-inch model ⇒ See page 344.
2. Remove the Heaters Control Assembly Fan by gently
pulling it from three rubber stand-offs.
3. Disconnect the cable of the Heaters Control Assembly
Fan.
Installation
4.
Remove the four screws from the old Heaters Control
Assembly Fan.
WARNING!: Switch off the printer and remove the power cable.
To Next Page
Loading...