Curing Fans & Cover 507
Removal & Installation
19. Remove all the T-10 screws that secure the front of the
Curing Fans Cover to the Printer.
Do not remove the screws that secure the Curing Grill
to the Curing Module, these do not need to be
removed.
20.Remove all T-20 screws from the top of the Curing Fans
Assembly.
21. Remove the Curing Fans Cover.
22.Place the Curing Fans Cover on the floor or a flat
surface.
CAUTION: We recommend that the last
screw to be removed is one of the central
screws. Take care when removing the last
holding screw, that holds the Curing Assembly
as it could fall.
To Next Page
Loading...