510 Chapter 8 Removal & Installation
Removal & Installation
Curing IR Temperature Sensor & Fan
Removal
1. Remove the Left Cover
⇒
See page 325
2. Remove the Left Curing Cover
⇒
See page 328.
3. Remove the Right Curing Cover
⇒
See page 330.
4. Remove the Curing Fans Cover
⇒
See page 503.
5. Loosen two screws on the connector of the Curing IR
Temperature Sensor cable, by hand or with a flat
screwdriver.
6. Disconnect the Curing Temperature Sensor Cable.
7. Disconnect the cable of the Curing Temperature Sensor
Fan.
WARNING!: Switch off the printer and remove the power cable.
To Next Page
Loading...