520 Chapter 8 Removal & Installation
Removal & Installation
24.Remove all the T-20 screws from the cable clamps that
secure cables to the front of the Curing Module. The
number of cable clamps will depend of the version of
the Printer.
25.Remove one cable clamp on the left side of the curing
Module.
26.Remove two T-10 safety grounding screws from the right
side of the Heaters.
To ensure the electrical safety of the printer, it is critical
that these screws are reinstalled at the installation.
27. Remove two T-10 screws from the left side of the
Heaters.
To Next Page
Loading...