524 Chapter 8 Removal & Installation
Removal & Installation
40.Be careful when removing the end of the Output heater
cable as there is a connector on the end, and this
could damage the isolation fiber.
41. Remove the Overdrive Heater taking care not to
damage the Isolation fiber.
42.Remove the other end of the Overdrive Heater
Installation
1. The ends of the two types of Curing Heaters are
different to avoid incorrectly installing them.
If the Heaters are installed swapped over, this will
trigger a system error.
NOTE: After installing the NEW Curing
Heaters perform the following:
• Reset the life counter “4.8.1 Reset Curing
Lamps”
⇒
page 201.
To Next Page
Loading...