HP Designjet L25500 Printer series - Page 577

Center Guide 571
Removal & Installation
Center Guide
Removal
1. Remove the Right Cover ⇒ See page 319 .
2. Remove the Left Cover ⇒ See page 325.
3. Remove the Primer Assembly ⇒ See page 355.
4. Remove the Right Connector Cover ⇒ See page 341.
5. Remove the Electronics Module ⇒ See page 483.
6. Remove the Service Station ⇒ See page 364.
7. Remove the Ink Supply Station ⇒ See page 388.
8. Remove the Media Sensor ⇒ See page 563.
9. Remove one T-15 screw (Type E) and two T-20 screws
(Type A), that secure the Center Guide, from the right
hand side of the Printer.
10. Remove two T-15 screws (Type E), that secure the
Center Guide, from the left hand side of the Printer.
WARNING!: Switch off the printer and remove the power cable.
Type A
Type E