Checking the resistance values 63
Troubleshooting
Calibrations Status
This page contains the following information:
• General Calibrations (performed by Service Engineers).
• Diagnostic Log
General Calibrations
• Printhead Alignment relates to the Printhead Alignment which changes to ‘pending’ when a
Printhead is replaced and the Printhead Alignment has not been performed.
• Drop Detector relates to the Drop Detector or Service Station calibration.
• Line Sensor relates to the Line Sensor Calibration.
Diagnostic log
This section displays the details of the Calibrations that have been performed on the printer, it also
contains useful information, such as if the particular calibration was successful or not.
NOTE: When a component is replaced, the corresponding calibration is NOT automatically
set to ‘NOT DONE‘. This is because the Printer does not know that there is a new part
installed.
To Next Page
Loading...