Change the graphic language setting
You can change the graphic language setting from the HP Utility with the following steps.
1. Under Windows, select the Settings tab then Printer settings > Printing preferences.
Under Mac OS, select Configuration then Printer settings > Configure printer settings > Printing
preferences.
2. Select one of the following options.
●
Select Automatic to let the printer determine which type of file it is receiving. This is the default
setting; it works for most software applications. You should not normally need to change it.
●
Select HP-GL/2 only if you are sending a file of that type directly to the printer, without going
through a printer driver.
●
Select PDF only if you are sending a file of that type directly to the printer, without going through a
printer driver (with the PostScript upgrade only).
●
Select PostScript only if you are sending a file of that type directly to the printer, without going
through a printer driver (with the PostScript upgrade only).
●
Select TIFF only if you are sending a file of that type directly to the printer, without going through
a printer driver (with the PostScript upgrade only).
●
Select JPEG only if you are sending a file of that type directly to the printer, without going through
a printer driver (with the PostScript upgrade only).
You can change the graphic language setting from the front panel. Select the Setup menu icon
, then
Printing preferences > Select graphic language. Select the desired option and press the OK key to set the
value.
NOTE: If the graphic language is set from the HP Utility, it overrides the front panel setting.
Paper suitability options
Paper mismatch action
If the paper currently loaded in the printer is not suitable for a particular job, the printer can either put the job
on hold until some suitable paper is loaded, or it can ignore the problem and print the job on the unsuitable
paper. There are several ways in which the loaded paper may be considered unsuitable:
●
The paper type is not as specified for the job
●
The paper source (roll 1, roll 2 or roll 3) specified for the job has no paper loaded
●
The paper size is smaller than specified for the job
You can set the printer's behavior in such cases from the front panel.
●
Select the Setup menu icon
, then Job management options > Paper mismatch action > Print
anyway if you want such jobs to print on whatever paper is loaded. This is the default option.
NOTE: The printer will print the job on the selected roll regardless of the size and type of the roll: if
the roll is too narrow for the job, the job will be clipped.
●
Select the Setup menu icon
, then Job management options > Paper mismatch action > Put job on
hold if you want such jobs to be put on hold. The printer will send an alert whenever a job is put on hold.
ENWW Change the graphic language setting 23
To Next Page
Loading...