Printhead replacement must be performed after the printer has been turned on with the hard power switch at
the back of the printer.
1.
At the front panel, select the
icon, then select Replace printheads.
2. The printer moves the carriage into the correct position.
CAUTION: If the carriage remains in the removal position for more than 3 minutes without inserting or
removing any printheads, it will attempt to return back to its home position to the right.
3. When the carriage has stopped moving, the front panel prompts you to open the printer window.
4. Locate the carriage on the right side of the printer.
ENWW Work with ink system components 49
To Next Page
Loading...