3. Insert the new printhead into its correct slot in the carriage.
CAUTION: Insert the printhead slowly and vertically, straight down. It can be damaged if you insert it
too quickly, or at an angle, or if you rotate it as you insert it.
4. Push down as indicated by the arrow.
CAUTION: You might feel some resistance when installing the new printhead, so you need to press it
down firmly but smoothly. You should hear a beep and see confirmation on the front-panel display that
the printhead has been inserted. If you have difficulty, see
Cannot insert a printhead on page 158.
5. Insert all of the other printheads that need to be installed, and close the carriage cover.
52 Chapter 5 Handle the ink system ENWW
To Next Page
Loading...