6. Make sure that the end of the blue handle catches the wire loop on the near side of the carriage.
7. Lower the handle to rest on the carriage cover.
When all of the printheads have been inserted correctly and the printer has accepted them, the printer
beeps.
NOTE: If the printer does not beep when you insert the printhead and the Replace message appears
on the front-panel display, you might need to reinsert the printhead.
8. Close the printer window.
9. The front-panel display confirms that all of the printheads are correctly inserted, and the printer starts
checking and preparing the printheads. The default routine process, when all printheads are changed,
takes about 18 minutes. If the printer identifies a problem when preparing the printheads, the process
takes longer, up to 30 minutes. For a single printhead insertion, the time varies between 10 and 20
minutes.
10. After all printheads are checked and prepared, the printhead realignment procedure runs automatically
if paper is loaded. See
Align the printheads on page 57.
11. Depending on the paper type, the paper advance calibration procedure may run automatically if paper is
loaded. See
Perform paper advance calibration on page 34.
ENWW Work with ink system components 53
To Next Page
Loading...