4. The printer resets the calibration flag. Press OK to return to the menu.
5. Turn off the printer and replace the Drop Detector.
6. Turn on the printer and calibrate the Drop Detector.
Drop Detector calibration
1. In the Service Calibrations submenu, select Drop Detector calibration and press OK.
2. In the Drop Detector Calibration submenu, select Calibrate Drop Detector and press OK.
3. When the following message appears on the front panel, press OK to continue with the
calibration, or press Cancel to exit.
4. The printer will start to calibrate the Drop Detector, which takes about 1 minute.
128 Chapter 6 Service calibrations ENWW
To Next Page
Loading...