2. In the Service Calibrations submenu, select Line Sensor calibration and press OK.
3. When the following message appears on the front panel, press OK to continue the calibration, or
press Cancel to exit.
4. If no paper is loaded, the following message is displayed.
If the wrong type of paper is loaded, the following message is displayed.
If you choose to load the paper manually, follow the instructions on the front panel.
5. The printer starts to calibrate the Line Sensor. When the Line Sensor has been calibrated, the
results are displayed on the front panel. Press OK to continue or Cancel to exit.
130 Chapter 6 Service calibrations ENWW
To Next Page
Loading...