HP DESIGNJET T7100 Monochrome Series - Page 62

Solution: Try the following operations on the Yellow Ink Cartridge (T7100) or the Matte Black Ink
Cartridge (T7100 Monochrome).
●
Remove the Ink Cartridge and reinstall it into the printer.
●
Replace the Ink Cartridge.
●
Check that the ISS to Cartridge cable is not damaged and is correctly connected to the Ink Supply
Tubes PCA.
●
Replace the ISS to Cartridge cable
ISS to Cartridge Cables on page 308.
SE 26.1:01
Cause: Bad contact detected in ISS slot 1 floater
Solution: Try the following operations on the Cyan Cartridge (T7100) or the Dark Gray Cartridge
(T7100 Monochrome).
●
Remove the Ink Cartridge and reinstall it into the printer.
●
Replace the Ink Cartridge.
●
Check that the ISS to Cartridge cable is not damaged and is correctly connected to the Ink Supply
Tubes PCA.
●
Replace the ISS to Cartridge cable
ISS to Cartridge Cables on page 308.
SE 26.2:01
Cause: Bad contact detected in ISS slot 2 floater
Solution: Try the following operations on the Matte Black Cartridge (T7100); the T7100 Monochrome
should not experience this error.
●
Remove the Ink Cartridge and reinstall it into the printer.
●
Replace the Ink Cartridge.
●
Check that the ISS to Cartridge cable is not damaged and is correctly connected to the Ink Supply
Tubes PCA.
●
Replace the ISS to Cartridge cable
ISS to Cartridge Cables on page 308.
SE 26.3:01
Cause: Bad contact detected in ISS slot 3 floater
Solution: Try the following operations on the Dark Gray Cartridge (T7100); the T7100 Monochrome
should not experience this error.
●
Remove the Ink Cartridge and reinstall it into the printer.
●
Replace the Ink Cartridge.
●
Check that the ISS to Cartridge cable is not damaged and is correctly connected to the Ink Supply
Tubes PCA.
●
Replace the ISS to Cartridge cable
ISS to Cartridge Cables on page 308.
52 Chapter 3 System error codes ENWW