Roll out of paper procedure
If the end of the paper is no longer attached to the roll use the following
procedure.
1. If you have already started the unload process, press the Cancel key
on the front panel to cancel that procedure.
2. Lift the blue lever on the left. If the front panel displays a warning about
the lever, ignore it.
3. Pull out the paper from the printer. Pull from wherever the paper is
accessible; the back of the printer is recommended.
4. Lower the blue lever.
5. If the front panel displays a warning message, press the OK key to
clear it.
Load a single sheet
There are two ways to load a sheet. The easy loading procedure is
recommended.
CAUTION
Any loaded roll or sheet must be unloaded before
loading a sheet, see
Unload a roll on page 18, and Unload a single
sheet on page 27.
WARNING!
For sheets thicker than 0.5mm, you must have space
behind the printer equal to the length of the sheet.
20 Chapter 3 Paper handling ENWW
Paper handling
To Next Page
Loading...
