1Introduction
Safety precautions
The following precautions ensure the proper use of the printer and prevent
the printer from being damaged. Follow these precautions at all times.
●
Use the power supply voltage specified on the nameplate. Avoid
overloading the printer's electrical outlet with multiple devices.
●
Ensure the printer is well-grounded. Failure to ground the printer may
result in electrical shock, fire, and susceptibility to electromagnetic
interference.
●
Do not disassemble or repair the printer yourself. Contact your local
HP Service Representative for service, see
Contact HP Support
on page 63.
●
Use only the electrical cord supplied by HP with the printer. Do not
damage, cut, or repair the power cord. A damaged power cord has risk
of fire and electric shock. Replace a damaged power cord with an HP-
approved power cord.
●
Do not allow metal or liquids (except those used in HP Cleaning Kits)
to touch the internal parts of the printer. Doing so may cause fire,
electric shock, or other serious hazards.
●
Power OFF the printer and unplug the power cable from the power
outlet in any of the following cases:
●
When placing your hands inside the printer
●
If there is smoke or an unusual smell coming from the printer
●
If the printer is making an unusual noise not heard during normal
operation
●
A piece of metal or a liquid (not part of cleaning and maintenance
routines) touches internal parts of the printer
●
During an electrical (thunder/lightning) storm
●
During a power failure.
ENWW
Safety precautions
1
Introduction
To Next Page
Loading...
Need help?
General
