HP Designjet Z3100 series Reference Guide

HP Start-Up Kit
The HP Start-Up Kit is the CD or DVD that comes with your printer; it
contains the printer's software and documentation, including introductory
multimedia tutorials to help you to get a good first print.
NOTE The HP Start-Up Kit is provided on CD in Japan, and on DVD
elsewhere in the world. The rest of this guide will refer to the DVD
version only.
The front panel
Your printer's front panel is located on the front of the printer, in the center.
It has the following important functions:
●
Assists you in troubleshooting issues
●
Is used to perform certain procedures, such as cutting and unloading
paper
●
Displays helpful animations to guide you through procedures
●
Displays up-to-date information about the status of the printer such as,
the ink cartridges, the printheads, the paper, and the print jobs
●
Displays warning and error messages, when appropriate, along with
audio alerts to call attention to a warning or message
●
Can be used to change the values of printer settings and thus change
the operation of the printer. However, settings in the front panel are
overridden by settings in the printer drivers, see Using your printer on
DVD.
2 Chapter 1 Introduction ENWW
Introduction

HP Designjet Z3100 series Specifications

General

Print Technology	Thermal Inkjet
Maximum Print Resolution	2400 x 1200 optimized dpi
Number of Inks	12
Ink Types	Pigment-based
Hard Disk	40 GB
Operating Systems Supported	Windows, macOS
Connectivity	USB 2.0, Ethernet
Media Handling	Roll feed
Print Languages	HP-GL/2, HP-RTL, CALS G4
Line Accuracy	+/- 0.1%
Dimensions (W x D x H)	1770 x 1047 mm
Media Sizes Supported	Up to 44 inches wide (roll), up to 42 x 60 inches (sheet)
Print Margin (roll)	5 mm (top), 5 mm (right), 5 mm (left), 5 mm (bottom)