5. Push down as indicated by the arrow shown below.
CAUTION: When installing the new printhead there may be some resistance, so you need to
press it down firmly but smoothly. You should hear a beep and see confirmation on the front-panel
display that the printhead has been inserted. If you have difficulty, see
Cannot insert a printhead
on page 168.
6. Insert any other printheads, that need to be installed, with the same procedure, then close the
carriage lid.
7. Ensure the end of the blue handle catches the wire loop on the near side of the carriage.
ENWW Insert a printhead 121
Ink and printheads
To Next Page
Loading...