3. Insert the new printhead into its correct slot in the carriage.
CAUTION: Insert the printhead slowly and vertically, straight down. It may be damaged if you insert it
too fast, or at an angle, or if you rotate it as you insert it.
4. Push down as indicated by the arrow shown below.
CAUTION: When installing the new printhead there may be some resistance, so you need to press it
down firmly but smoothly. You should hear a beep and see confirmation on the front-panel display that
the printhead has been inserted. If you have difficulty, see
Cannot insert a printhead on page 145.
5. Insert all other printheads that need to be installed, and close the carriage lid.
104 Chapter 13 Handling ink cartridges and printheads ENWW
To Next Page
Loading...
