6. Ensure the end of the blue handle catches the wire loop on the near side of the carriage.
7. Lower the handle to rest on the carriage cover.
When all the printheads have been inserted correctly and are accepted by the printer, the printer beeps.
NOTE: If the printer does not beep when you insert the printhead and the Replace message appears
on the front-panel display, the printhead may need to be reinserted.
8. Close the window.
9. The front-panel display confirms that all printheads are correctly inserted. The printer starts checking
and preparing the printheads. The default routine process, when all printheads are changed, takes 10
minutes. If the printer finds problems in preparing the printheads, it takes longer, up to 45 minutes. For
a single printhead insertion, the times vary between 2 and 40 minutes. After all printheads are checked
and prepared, the printhead realignment procedure runs automatically if paper is loaded, see
Align the
printheads on page 148.
10. You are recommended to perform a color calibration after inserting a new printhead. See
Color
calibration on page 73.
ENWW Insert a printhead 105
To Next Page
Loading...
