HP Designjet Z5400 - The print is scuffed or scratched; Ink marks on the paper

8. Lower the blue lever.
9. Close the window.
10. Switch on the printer.
11. Reload the roll, or load a new sheet see Paper handling on page 33.
NOTE: If you find that there is still some paper causing an obstruction within the printer, restart the
procedure and carefully remove all pieces of paper.
A strip stays on the output tray and generates jams
If a small piece of paper (200 mm or smaller) has been cut, such as before (if new roll) and after a full-bleed
print or after the front-panel option Form feed and cut has been used, the cut strip remains in the output
tray. Only when the printer is not printing, reach into the tray and remove the strip.
ENWW A strip stays on the output tray and generates jams 125