If you have followed these instructions but failed to get through to the Embedded Web Server, see Cannot
access the Embedded Web Server on page 154.
Change the language of the HP Utility
The HP Utility can work in the following languages: English, Portuguese, Spanish, Catalan (Windows only),
French, Italian, German, Russian, Simplified Chinese, Traditional Chinese, Korean and Japanese.
●
Under Windows, select Tools > Set Language and select a language from the list.
●
Under Mac OS X, the language is changed as for any other application. In System Preferences, select
International and re-launch the application.
Change the language of the Embedded Web Server
The Embedded Web Server can work in the following languages: English, Portuguese, Spanish, Catalan,
French, Italian, German, Russian, Simplified Chinese, Traditional Chinese, Korean and Japanese. It uses
whichever language you have specified in your Web browser's options. If you have specified a language that
it cannot support, it works in English.
To change the language, you must change your Web browser's language setting. For example, in Internet
Explorer version 6, go to the Tools menu and select Internet Options, Languages. Then ensure that the
language you want is at the top of the list in the dialog box.
Change the sleep mode setting
If the printer is left switched on but unused for a certain period of time, it goes automatically into sleep mode
to save power. To change the time the printer waits before it goes into sleep mode, go to the front panel and
press
, then , then Setup > Front panel options > Sleep mode wait time. Select the wait time you
want and then press OK; you can set the time from 30 to 240 seconds. The default time is 30 seconds.
Turn the buzzer on and off
To turn the printer's buzzer on or off, go to the front panel and press , then , then Setup > Front
panel options > Enable buzzer, and select on or off. By default, the buzzer is set to on.
Change the front-panel display brightness
To change the brightness of the front-panel display, press , then , then Setup > Front panel
options > Select display brightness, and select a value you want. Press OK to set the value. The default
brightness is set to 50.
Change the units of measurement
To change the units of measurement in the front-panel display, press , then , then Setup > Front
panel options > Select units, and select English or Metric. By default the units are set to metric.
Configure network settings
You can view and configure the network settings from the Embedded Web Server, the HP Utility or the front
panel.
To do so with the Embedded Web Server, select the Setup tab, then Networking.
30 Chapter 4 Personalizing the printer ENWW
To Next Page
Loading...
