With the HP Utility under Windows, select the Settings tab, then Network Settings. Under Mac OS X, select
Configuration > Network Settings.
The following settings are available.
●
IP Configuration method: Specify the way to set an IP address, selecting BOOTP, DHCP, Auto IP or
Manual.
●
Host name: Specify the IP name of the printer. The name may contain up to 32 ASCII characters.
●
IP address: Specify the IP address of the printer. Duplicate IP addresses on a TCP/IP network will cause
communication to fail.
TIP: Make sure that the combination of IP address, subnet mask and default gateway is valid. If these
three fields are inconsistent, you may not be able to connect to the printer at all until you fix the
problem from the front panel.
TIP: If you change the current IP address and click Apply, the browser loses the current connection to
the printer because it is pointing to the old address. To reconnect, browse to the new IP address.
●
Subnet mask: Specify a subnet mask, which determines which bits specify the network and which bits
uniquely specify the node within the network.
●
Default gateway: Specify the IP address of a router or computer that is used to connect to other
networks or sub-networks. If none exist, use the IP address of the computer or the IP address of the
printer.
●
Domain name: Specify the name of the DNS domain in which the printer resides (for example,
support.hp.com).
NOTE: The domain name does not include the host name: it is not the fully qualified domain name,
such as printer1.support.hp.com.
●
Idle timeout: Specify the time that an idle connection is allowed to remain open when a remote
computer is waiting for the printer. The default value is 280 seconds. If set to zero, the timeout is
disabled and the connection is allowed to remain open indefinitely.
●
Default IP: Specify the IP address to use when the printer is unable to obtain an IP address from the
network when powered on or when reconfigured to use BOOTP or DHCP.
●
Send DHCP requests: Specify whether DHCP requests are transmitted when a legacy default IP address
or a default Auto IP is assigned.
To configure the same network settings from the front panel, press
, then , then Connectivity >
Network connectivity > Gigabit Ethernet > Modify configuration.
You have various other options available from the Connectivity > Network connectivity > Advanced menu.
●
I/O timeout: Specify the time that an idle connection is allowed to remain open when the printer is
waiting for a remote computer. The default value is 30 seconds. If set to zero, the timeout is disabled
and the connection is allowed to remain open indefinitely.
●
Allow SNMP: Specify whether SNMP is permitted.
●
Embedded Web Server > Allow EWS: Specify whether the Embedded Web Server is enabled.
●
Web Services > HP Utility software: View the HP Utility software settings.
●
Web Services > Color and paper management: View the color and paper management settings.
●
Restore factory settings: restore the initial default values of the network settings.
ENWW Configure network settings 31
To Next Page
Loading...
