122 Chapter 4 Service Tests and Utilities
Tests and Utilities
8. Once the test is completed, OK will be displayed on the Front Panel.
13. A e ro so l Te s t
The purpose of this test is to verify the operation of the Color Sensor.
Perform the Aerosol test as follows:
1. In the Service Tests submenu, scroll to “13. Aerosol Test” and press Enter.
2. This test has not yet been implemented.
14. P rim er Tes t
The purpose of this test is to prime a specified Printhead.
Perform the Primer test as follows:
1. In the Service Tests submenu, scroll to “14. Primer Test” and press Enter.
2. The Printer will start the Primer test and the Front Panel will display the following messages:
• Starting Sausalito.
If there is a failure starting the Sausalito, the Front Panel will display System Error Code 01.0:10.
For more information on troubleshooting this error code, refer to page 47.
• Starting GpioPwmImpact.
If there is a failure starting the SuppliesConf, the Front Panel will display System Error Code
XX.X:XX. For more information on troubleshooting this error code, refer to page 47.
• Set GPIO psu_lpm.
If there is a failure at this point, the Front Panel will display System Error Code 01.0:10. For
more information on troubleshooting this error code, refer to page 47.
NOTE: If the customer reports color issues even through the test has passed, perform the
Spectrophotometer test on page 148.
NOTE: IF POSSIBLE ALWAYS PERFORM THIS TEST BEFORE REPLACING THE PRIMER. IF
THIS TEST PASSES, DO NOT REPLACE THE PRIMER.
To Next Page
Loading...