Entering the Service Tests Menu 121
Tests and Utilities
3. The following message is displayed on the Front Panel, press any key to continue.
4. The Color Sensor information is read and the following message is displayed on the Front Panel,
press any key to continue.
5. When the following message is displayed on the Front Panel, raise the Media Lever, load paper,
lower the Media Lever, and press any key to continue.
6. The Printer will read the Red Reference and the Front Panel will display the following messages:
• Starting ColorSensor…
• Starting ColorSensing
• Reading SOL Status
• Reading Registers
• Switching on fans
• Performing Calibration…
• Uncapping SVS
• Reading Red Reference
7. The Front Panel then displays the deltaE value, press any key to continue.
To Next Page
Loading...