142 Chapter 4 Service Tests and Utilities
Tests and Utilities
7. Replace Cutter
The purpose of this Service Utility is to move the Carriage to a position where the Cutter can be replaced
easily.
Perform the Replace Cutter utility as follows:
1. In the Service Utilities submenu, scroll to “Replace Cutter” and press Enter.
2. When the following message appears on the front panel, you must select whether you would like to
continue with replacing the Cutter by pressing the Enter key. Press Back or Cancel to exit the
utility.
3. The Carriage will move to the Cutter replacement position and the following message will be
displayed on the Front Panel. After a few seconds the Printer will begin to shutdown.
4. Before replacing the Cutter, make sure that you switch the Printer OFF from the rear.
8. Set RTC Clock
The purpose of this Service Utility is to set the Real Time Clock of the Printer.
Perform the Set RTC Clock utility as follows:
1. In the Service Utilities submenu, scroll to “Set RTC Clock” and press Enter.
To Next Page
Loading...