Service Utilities 145
Tests and Utilities
• Allowing pens not operational.
If there is a failure at this point, the Front Panel will display an error code. For more information on
troubleshooting this error code, refer to page 47.
5. If the utility exits correctly, OK will be displayed on the Front Panel.
11. O p e n / C l o s e S O L
The purpose of this Service Utility is to open and close the Color Sensor shutter to verify correct operation.
Perform the Open/Close SOL utility as follows:
1. In the Service Utilities submenu, scroll to “Open/Close SOL” and press Enter.
2. When the following message appears on the Front Panel, you must select whether you want to
perform the Open/Close SOL Service Utility by pressing Enter. Press Back or Cancel to exit the
utility.
3. The Printer will perform the Open/Close SOL test and the Front Panel will display the following
messages:
• Performing SOL Full Calibration.
• Checking ColorSensor Status.
• Reading Lab values with SOL Shutter Closed.
• Opening SOL Shutter
• Reading Lab values with SOL Shutter Open
• Analyzing SOL Shutter Open status.
If there is a failure at this point, the Front Panel will display System Error Code 58:10. For more
information on troubleshooting this error code, refer to page 68.
4. If the utility exits correctly, OK will be displayed on the Front Panel.
12. Disk Wipe DoD 5330.22’M
The purpose of this Service Utility is to securely erase data on the Hard Disk according to the directive
DoD 5220.22-M.
The printer's hard disk is used as a temporary storage area for print jobs. The Secure Disk Erase facility
can completely erase your information from the hard disk to protect it from unauthorized access.
To Next Page
Loading...