Entering the Service Calibrations Menu 161
Service Calibrations
13. Load the Calibration Pattern following the instructions on the Front Panel. Once the Calibration
Pattern is loaded correctly, the following message will be displayed on the Front Panel. Press the
Enter key to continue.
14 . The Printer will scan the Calibration Pattern which could take several minutes. Once the calibration is
completed successfully, the following message will be displayed on the Front Panel. Press the Enter
key to continue.
If the Paper Advance Calibration fails for any reason, a warning message will appear on the Front
Panel. In this case, try the following:
• Check that the Calibration Pattern was not incorrectly cut (trimming the actual pattern) during
the media load process. If this is the case, perform the Paper Advance Calibration again from
step 1.
• Perform a Line Sensor Calibration (⇒
See page 163) and then re-scan the Calibration pattern.
• Replace the Line Sensor ⇒ See page 390.
NOTE: Only scan the Calibration Pattern in the Printer that was used to actually print it.
Using the Calibration in a different Printer could cause it to experience media advance
problems. After scanning the Calibration Pattern, it should be discarded.
NOTE: When Loading the Calibration Pattern, use the Cutter blade on the Print Platen to
align the edge of the sheet. If you follow this advise, you will prevent the cutter from cutting a
section of the Calibration Pattern, which could cause the Calibration to fail.
To Next Page
Loading...