Top Cover (42-inch) 273
Removal & Installation
Top Cover (42-inch)
Removal
1. Remove the Right Cover
⇒
See page 264
.
2. Remove the Left Cover
⇒
See page 270
.
3. Release the three clips securing the Ink Supply Tubes
and the Trailing Cable to the Top Cover.
4. Release the Ink Supply Tubes and Trailing Cable from
the clip underneath the Top Cover.
5. Remove the Ink Supply Tubes and Trailing Cable from
within the Top Cover and lay them on the Print Platen.
WARNING!: Switch off the printer and remove the power cable.
NOTE: Throughout this section the graphics actually show the HP Designjet 4000 Printer series but the
steps of the procedure are identical for the HP Designjet Z6000 Printer series.
To Next Page
Loading...