HP Designjet Z6100 Printer series - Page 293

Rear Door (60-inch) 283
Removal & Installation
Rear Door (60-inch)
Removal
1. Remove the Left Cover ⇒ See page 270 .
2. Remove seven T-15 screws (Type G) and the four T-15
screws (Type X) from the Rear Door.
3. Open the Rear Door slightly (as shown, approximately
30 degrees).
4. Lift the left side of the rear door sufficiently to release it
from the location stud.
WARNING!: Switch off the printer and remove the power cable.
Type
NOTE: Each Type X screw includes a washer
(part number 3050-1267).