Left Connector Cover (42-inch) 287
Removal & Installation
Left Connector Cover (42-inch)
Removal
1. Remove the Rear Door
⇒
See page 281
.
2. Remove two T-20 screws (Type B) from the Left
Connector Cover.
3. Remove the Left Connector Cover from the Printer.
WARNING!: Switch off the printer and remove the power cable.
NOTE: Throughout this section the graphics actually show the HP Designjet 4000 Printer series but the
steps of the procedure are identical for the HP Designjet Z6000 Printer series.
To Next Page
Loading...