312 Chapter 8 Removal & Installation
Removal & Installation
Ink Supply Tubes and Trailing Cable
Removal
1. Remove the Right Cover
⇒
See page 264
.
2. Remove the Left Cover
⇒
See page 270
.
3. Remove the Top Cover
⇒
See page 277
.
4. Remove the Rear Door
⇒
See page 283.
5. Remove the Right Connector Cover
⇒
See page 285
.
6. Disconnect the Trailing Cable from the Interconnect
PCA and the Sausalito PCI.
7. Release the Trailing Cable from the cable clamp.
WARNING!: Switch off the printer and remove the power cable.
CAUTION: You MUST NEVER replace both the Hard Disk Drive and the Ink Supply Tubes and Trailing
Cable at the same time. If both parts need to replaced, you MUST first replace one part and then power
ON the Printer until it completely initializes. Then you can power OFF the Printer and replace the other
part.
To Next Page
Loading...