HP Designjet Z6100 Printer series

328 Chapter 8 Removal & Installation
Removal & Installation
Left Spittoon
Removal
1. Remove the Left Cover ⇒ See page 270 .
2. Remove:
• The Left Connector Cover or the 42-inch model ⇒
See page 287 .
• The Electronics Module Extension the 60-inch model ⇒
See page 288 .
3. Remove the Scan-Axis Motor ⇒ See page 346 .
4. Disconnect the Left Spittoon Fan cable from the
PrintMech PCA.
5. Unroute the Left Spittoon Fan cable.
WARNING!: Switch off the printer and remove the power cable.