Media-Axis Motor 349
Removal & Installation
Media-Axis Motor
Removal
1. Remove the Left Cover
⇒
See page 270
.
2. Remove the Rear Door
⇒
See page 283
.
3. Remove:
• For the 42-inch model, the Left Connector Cover
⇒ See page 287.
• For the 60-inch model, the Electronics Module
Extension⇒ See page 288.
4. Disconnect the Media-Axis Motor cable from the
PrintMech PCA.
5. Detach the clamp of the ferrite core of the Media-Axis
Motor cable from the printer chassis.
WARNING!: Switch off the printer and remove the power cable.
To Next Page
Loading...