350 Chapter 8 Removal & Installation
Removal & Installation
6. Remove the T-15 screws (Type R) identified (A) and
loosen the T-15 screws (Type R) identified (B) that
secure the Media-Axis Motor.
7. Remove the Media-Axis Motor Bracket.
8. Remove two T-20 screws (Type B) that secure the
Media-Axis Motor Bracket.
9. Remove the Media-Axis Motor from the Printer.
• Paper Advance Calibration
⇒
Chapter 5.
NOTE: When reinstalling the parts, make sure
you apply the grease (included with the support
part) to the gears.
NOTE: After installing the NEW Media-Axis
Motor, make sure you perform the following
Service Calibration:
To Next Page
Loading...