Optical Media Advance Sensor (OMAS) 351
Removal & Installation
Optical Media Advance Sensor (OMAS)
Removal
42-inch model ONLY
1. Open the Rear Door. and go to step 4.
60-inch model ONLY
2. Remove the Left Cover
⇒
See page 270
.
3. Remove the Rear Door
⇒
See page 283
.
Both models
4. Remove media if installed.
5. Squeeze the clips to unclip the Media Sensor from the
Center Guide.
6. Let the Media Sensor hang below the Center Guide.
This is to ensure it does not get damaged by the
ribbon cable of the OMAS during the removal
procedure.
WARNING!: Switch off the printer and remove the power cable.
NOTE: The removal procedure differs depending on the Printer model, 42-inch or 60-inch.
To Next Page
Loading...