How to Interpret the Service Information Pages 27
Troubleshooting
• Media Specific Calibrations (performed by the User).
General Calibrations
• Printhead Alignment relates to the Printhead Alignment which changes to ‘pending’ when a
Printhead is replaced and the Printhead Alignment has not been performed.
• Drop Detector relates to the Drop Detector or Service Station calibration.
• Line Sensor relates to the Line Sensor Calibration.
Media Specific Calibrations
This section shows the following for each type of media:
• Media Name.
• Color.
• Paper Advance.
NOTE: When a component is replaced, the corresponding calibration is NOT automatically
set to ‘NOT DONE‘. This is because the Printer does not know that there is a new part
installed.
To Next Page
Loading...